Date: | June, 25 2003 at 18:28:46 | Description: | Here I have stripped the trunk out. The interior paneling on the trunk of the
EVO is held on by little latching grommet thingies. They have a pin going down
the center, which needs to be pushed all the way through the ring in order to
remove them. You should remove the back peice first, (against the seat).
After removing this, you should be able to put your hand behind each of the
grommets, and hold onto the pin. If you do not, it will fall down into the
car, requiring hours of fishing around to get out. The pin usually has to come all the way out to be removed. The back peice, near the trunk latch, requires
you to lift it straight up, as there are two plastic hooks that latch into the
side pieces. Do not pull it straight out. | Camera Settings: | Camera model : Canon PowerShot G1
Resolution : 2048 x 1536
Flash used : No
Focal length : 7.0mm (35mm equivalent: 35mm)
CCD Width : 7.06mm
Exposure time: 0.020 s (1/50)
Aperture : f/2.2
Focus Dist. :65.54m
Metering Mode: center weight
Jpeg process : Baseline
|
|