Date: | September, 10 2008 at 18:36:53 | Description: | The door spike is takced on, and now I'm trying to figure out how to make
the piece that it meets up with on the main body. I started with an
oversized piece, and put the gradual bend into it by hammerforming it over a
radiused chunk of wood. Basically I did the top bend first, then figured
out where to cut to meet the spike, and then later bend the bottom part and
cut off the excess as I went. | Camera Settings: | Camera model : KODAK V550 ZOOM DIGITAL CAMERA
Resolution : 2576 x 1932
Flash used : Yes (auto)
Focal length : 6.2mm (35mm equivalent: 36mm)
Exposure time: 0.017 s (1/60)
Aperture : f/2.8
ISO equiv. : 80
Whitebalance : Auto
Metering Mode: matrix
Exposure : program (auto)
|
|